Skip to content

Render repair and restoration in Devon

Cracked, hollow or blown render doesn't always mean starting again. We find out what's behind the damage and whether a repair will hold. We do repairs, re-renders and insulation, so we'll recommend the route your wall actually needs.

Cause first

we find out why it failed before we fix it

3 routes

repair, re-render, or re-render with insulation

Like for like

repaired in the same type of render as the wall

Free survey

a look at the wall and a written quote

Can your render be repaired?

Most render can be repaired if the damage is local and the render around it is still firmly stuck to the wall. The quick check is to tap it: sound render gives a solid knock, blown render sounds hollow. If the hollow patches are small, we cut back to sound edges and make good. If they're everywhere, patching won't last.

Why it failed matters as much as the fix. Water getting in behind, hard cement on an old wall, a leaking downpipe, or ground levels built up over the base. Fix the patch without fixing the cause and the same problem tends to come back within a few winters.

Where patching won't last, there are two other routes: a full re-render, or re-rendering with external wall insulation while the scaffold's up. The table below sets all three side by side.

Cracked and blown render

Patch it, redo it or insulate

A failing wall usually comes down to three routes: repair what's there, strip it and render again, or insulate the house while the scaffold is up. We do all three, and we'll recommend the one your wall needs.

FeatureRepairFull re-renderRe-render with insulation
What's involvedDamaged areas cut back to sound render and made goodEverything stripped back to the wall and rendered againStripped back, insulation boards fitted, finished to the approved system
CostThe smallest billBiggerBiggest, but it can cut heat loss through the walls
LooksA repair rarely vanishes completelyA uniform, new finishA uniform, new finish in your colour
Right whenThe damage is local and the rest is soundRender is failing across whole areasYou're re-rendering anyway and the walls suit it
Watch out forPatching a wall that's failing everywhereCement going onto an old wall that needs limeOlder walls needing a vapour-open system

The repair jobs we see most

Driving rain off the Atlantic is hard on render, so there's no shortage of this work round here.

Cracked render

Hairline cracks raked out and filled, wider ones cut out and repaired with mesh. Wide or stepped cracks go to a structural engineer before we touch them.

Blown render

Hollow areas cut back to where it's sound, then rebuilt in the same kind of render so it moves the same way.

Tired finishes

Sound but grubby or faded render cleaned down and recoated, often in a through-coloured silicone or spray cork finish.

Cement off, lime on

Hard cement stripped from cob or stone and replaced with traditional lime render, so the wall can dry out.

How we repair render

  1. Look and tapWe go over the wall, tap for hollow areas and mark up what's failing.
  2. Find the causeGutters, downpipes, ground levels, the wrong render on the wrong wall. We look for why.
  3. Quote with optionsRepair, re-render or upgrade, in writing, with what we'd do and why.
  4. Cut back and prepareDamaged render cut back to sound edges, loose material out, surfaces cleaned.
  5. RepairRebuilt in a matching render type, with mesh across cracks where it's needed.
  6. Finish and checkBlended or recoated as agreed, then a walk round together.

Render repair questions

House in Langtree with new base coat under scaffold
Can cracked render be repaired, or does it all need to come off?

Often it can be repaired. If the cracks are local and the render around them is still firmly stuck to the wall, we cut out and repair the damaged areas. If large areas sound hollow when tapped, patching won't last and a re-render is the better option.

What does blown render mean?

Blown render has come away from the wall behind it, usually because water has got in and frozen, or the render was never properly bonded. It sounds hollow when tapped and can bulge or fall away. Blown areas need cutting back to sound render and rebuilding.

Will a render repair match the existing wall?

We match the type and texture of render as closely as we can, but a patch on older render rarely disappears completely, especially once it has weathered. If an even look matters, recoating the whole elevation gives a uniform finish.

Why is my render cracking?

Common causes are movement in the wall, the wrong render for the background, such as hard cement on an old solid wall, water getting in behind, or render applied too thick or in poor weather. Wide or stepped cracks can point to a structural problem, which needs checking by an engineer first.

Can failing render cause damp inside?

It can. Cracked or blown render lets rain into the wall, and hard cement on an older wall can stop it drying out. Damp can have other causes too, so we look at the whole wall, the gutters and the ground levels before recommending a fix.

Is it worth insulating when re-rendering?

It's often the best time to do it. If the old render is coming off anyway, the scaffold and much of the preparation are already part of the job. We'll price both so you can compare, and we'll tell you if insulation isn't right for your walls.

Free quote

Tell us about
your walls

A name, a number and a rough idea of the job is plenty. We'll come out, have a proper look and give you a written quote.

We work across Devon, from Barnstaple and Bideford to Exeter and Plymouth, and over the border into Cornwall and Somerset. Send a postcode and we'll arrange a time to come and see you.

Rather talk? Ring 07951 779552

Cookie settings

Choose which cookies we can use. You can change this at any time from the "Cookie settings" link at the bottom of every page. More about the cookies we use.

Strictly necessary cookies
Strictly necessaryAlways on

Needed for the site to work, for example remembering your cookie choice. These can't be switched off.

Analytics cookies

Google Analytics tells us which pages are read and how people find the site. It doesn't identify you. Off unless you switch it on.